Official Luthiers Forum!

This has been probably been covered before but what's the thoughts on slotting the bridge and using unslotted pegs
Just read it improves sound and response as more contact ?
Here's pic I just seen

Not so sure about the sound and response, but certainly a big improvement in longevity of the bridge plate and pins.
Lottsa posts on this.

_________________
The name catgut is confusing. There are two explanations for the mix up.

Catgut is an abbreviation of the word cattle gut. Gut strings are made from sheep or goat intestines, in the past even from horse, mule or donkey intestines.

Otherwise it could be from the word kitgut or kitstring. Kit meant fiddle, not kitten.

More posts on this than you can shake 100 sticks at.... most are in full agreement, unslotted pins good, slotting bridge/plate good.

_________________
My Facebook Guitar Page

"There's really no wrong way, as long as the results are what's desired." Charles Fox

"We have to constantly remind ourselves what we're doing....No Luthier is putting a man on the moon!" Harry Fleishman

"Generosity is always different in the eye of the person who didn't receive anything, but who wanted some." Waddy Thomson

Agree with the "less damage to bridge plate". Disagree with the concept that more contact= more energy transmission. A common belief but unsubstantiated.

Slotting a bridge is good. I do it all the time. The photo also shows slots on the saddle which is a bad idea. At least I had bad results with that.

I think a lot of people slot and ramp their bridges. Not sure how many slot their saddles for improved contact. Could certainly give you more of a break angle when you are using a wider saddle blank for intonation.

At least that's what I see in the picture in the OP.

Tim

What do you guys use to slot the bridge..my nut files are to big for this task

Dremel tool with dental bits.

You can make an efficient tool using a very fine tooth saber saw blade/s (at least 22 tpi) I found the saw sold specially for this purpose way too course and actually useless.

_________________
Ken Cierp

http://www.kennethmichaelguitars.com/

Zona saw keyhole blade, and knife style needle file.

Remember that if you want the guitar to support medium gauge strings, to make the slots big enough for them. Conversely, narrow slots are a nice way to hint to future owners if a guitar is meant for lights only

Along these lines if you like Tomastik strings slot bigger.... they have very wide windings.....

PS: One more thing: With instruments with the bridge design being marginal for break-over angle slotting the bridge, top and plate can add break angle.

I reshaped some jigsaw blades on a grinder. They've worked well for me.

Brent

Ervin Somogyi has had pretty good results with it...


Sent from my iPhone using Tapatalk

_________________
Mountain Song Guitars www.mountainsongguitars.com

I don't think the slotted saddle is what makes his guitars sound good. More likely the super thin tops and bracing.

But I invite others to try this. Take one of your nice sounding guitars and make a slotted saddle for it and compare them. The one time I did this (on a Breedlove) the slotted saddle literally ruined not only the tone but also the volume. It was dramatic. I would be interested in hearing if other builders have the same results.