Official Luthiers Forum!

Any body know if Zpoxy and seagraves vinyl sealer are compatible?
I'm concerned about adhesion.

I assume you are going to be doing the pore fill prior to the sealer. If that is the case there should be no adhesion problems as long as the surface is left rough enough for the sealer to grab on to. I would not sand any finer than 180grit before applying the sealer. If you do a z-poxy wash after the pore fill as a lot do these days the z-poxy would act as a sealer itself and the vinyl would most likely not really be necessary as long as the surface is not to smooth for the lacquer to grab on to.

_________________
Brian

You never know what you are capable of until you actually try.

https://www.howardguitarsdelaware.com/