Official Luthiers Forum!

When I used to use saws for a living including table and radial arm saws there used to be a lot of disagreement on what was ok or not too. I sure ain't no novice and I sure ain't interested in doing that.

I should say I ain't doing it any more because I used to do cove cuts with all the saws back in the day.

_________________
Steve Smith
"Music is what feelings sound like"

I have done cove cuts on a radial arm saw, and I can see how you might do this on a RA saw, but with a stop on the track, but, with a RA, you can, at least, see what's going on.

_________________
Waddy

Photobucket Build Album Library

Sound Clips of most of my guitars

I can't imagine freehanding it on the table saw, but with a guide board perpendicular to the blade, and an inch of blade showing, I cut about 2 mm and then keep moving it closer til it's cut what I want. A 10" blade makes a good shape. I stand to the side, not in front though.

I use this method with a 10" blade and it`s very safe with a sled and a stop.It`s fast and easy and makes a great shape.In my opinion any power tool can obviously be dangerous.Experience and common sense is what makes tools safer.
james

_________________
James W Bolan
Nashville Tennessee

The 3rd. photo, I believe, shows the loss of 3 fingers after flipping the neck over. AMAZING....no blood shown here :-0
Is it possible the brim of the hat is 3 ft. long?

I've done a little of this method of removal over the years with odd projects with specific requirements...but overall find it a little too challenging and unpredictable for my liking.....and would also probably have my face in it to see the depth marks and blade location. Not a great position to be in. Watch out for those hoodie ties hanging down.

KB

_________________
Wood Creations by Kent A. Bailey
EXCELLENCE IN SCULPTURE, CARVING, LUTHIER, ARCHITECTURAL MILLWORK AND DESIGN

http://www.kabart.com

Thanks

This sounds like something I should stay away from

Richard