| Official Luthiers Forum! https://www.luthiersforum.com/forum/ |
|
| cherry neck blank source https://www.luthiersforum.com/forum/viewtopic.php?f=10102&t=15303 |
Page 1 of 1 |
| Author: | Eric Mathre [ Wed Jan 09, 2008 7:00 am ] |
| Post subject: | |
Hi, Today I have cherry on my mind. I have a couple of back and side sets of cherry from the recent swap meet. I'm looking for a source for cherry neck blanks. I haven't seen this listed on anyone's site (and since I've also been suffering post-swap meet, AC-Woods-and-Colonial hiatus, RC moving WAS withdrawl, I've been looking). I want 30 in by approx 1 in for a scarf joint, stacked heel approach. Figure is optional. Is curly cherry prone to tearout like curly maple?) Thanks, Eric |
|
| Author: | Eric Mathre [ Wed Jan 09, 2008 7:02 am ] |
| Post subject: | |
Only 9 days until we have "edit" functionality... The dimensions I meant are 30 in by 3 in by approx 1 in. Thanks, Eric |
|
| Author: | Dennis Leahy [ Wed Jan 09, 2008 7:23 am ] |
| Post subject: | |
Check with the Zootman. I know he has some. Dennis |
|
| Author: | joelThompson [ Wed Jan 09, 2008 9:04 am ] |
| Post subject: | |
Eric i know this may not be relevent to you but this may interest the european guys. I have just sorced a couple of cubic feet of nice quartersawn cherry for necksblanks. All my neck blanks are 800mm x 75mm x 25mm minimum for scarfe necks with staked heels. I have had so many inquires for cherry necks over the past few weeks i think it will be a regular thing from now on. My cherry neck blanks will be priced ?12.50 (or $25) and be resawn and planed up in two to three weeks. If you need one in a hurry just give me a yell and i will cut one for ya. All you U.S guys it would recomend bob c any time as all his wood is first class (plus the shipping wont kill ya) and his service is spot on. Joel. |
|
| Author: | Jim Kirby [ Wed Jan 09, 2008 10:43 am ] |
| Post subject: | |
If you don't want curly, I can send you one that I cut myself. Same dimensions you are asking for. I cut about 12 blanks from a board this summer, but they are all straightgrained and pretty featureless. Jim |
|
| Author: | Greg [ Wed Jan 09, 2008 1:58 pm ] |
| Post subject: | |
I have found lots of nice wood on ebay. I built one cherry neck recently and found the weight is quite a bit more than mahogany or maple. I',m still getting used to the balance. It looks beautiful though. |
|
| Author: | Don A [ Thu Jan 10, 2008 6:43 am ] |
| Post subject: | |
Greg, I have purchased a few cherry necks (mahogany and walnut as well) from Melrose Millworks. Of course this wouldn't be an option if you have your mind set on carving your own. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|