| Official Luthiers Forum! https://www.luthiersforum.com/forum/ |
|
| Malaysian Blackwood https://www.luthiersforum.com/forum/viewtopic.php?f=10101&t=49290 |
Page 1 of 1 |
| Author: | stan thomison [ Wed Apr 26, 2017 12:09 pm ] |
| Post subject: | Malaysian Blackwood |
Need source for a Malaysian bridge and tuner buttons for build end pins. Yeah I know, good luck with that |
|
| Author: | Chris Ensor [ Wed Apr 26, 2017 2:56 pm ] |
| Post subject: | Re: Malaysian Blackwood |
A bridge blank would be relatively easy- just buy some lumber. And from that lumber you can make (or have them made) some buttons and an end pin. What tuners are you going to be putting the buttons on? I just finished making a set for some gotoh 510s. |
|
| Author: | stan thomison [ Thu Apr 27, 2017 7:58 am ] |
| Post subject: | Re: Malaysian Blackwood |
Chris I will be putting on either Waverly or Gotoh. I would make one as noted, however at this time not tooled up to do this kind of thing. You still in Ozark or Nixa? |
|
| Author: | klooker [ Thu Apr 27, 2017 8:01 am ] |
| Post subject: | Re: Malaysian Blackwood |
Did you try Burton LeGeyt? He's made tuner buttons for Waverly's in the past. |
|
| Author: | Tim L [ Thu Apr 27, 2017 11:00 am ] |
| Post subject: | Re: Malaysian Blackwood |
+1 for Burton |
|
| Author: | Chris Ensor [ Thu Apr 27, 2017 2:06 pm ] |
| Post subject: | Re: Malaysian Blackwood |
stan thomison wrote: Chris I will be putting on either Waverly or Gotoh. I would make one as noted, however at this time not tooled up to do this kind of thing. You still in Ozark or Nixa? Springfield |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|