Chris, the hole centers on mine are a rectangle. It looks like they were shooting for 76mm x 68mm They almost got it.
center of spindle seems to be deliberately set 3mm off center on 68mm side.
| Official Luthiers Forum! https://www.luthiersforum.com/forum/ |
|
| Colt Plunge Base Holes https://www.luthiersforum.com/forum/viewtopic.php?f=10101&t=49004 |
Page 1 of 1 |
| Author: | Chris Ensor [ Tue Feb 14, 2017 10:30 am ] |
| Post subject: | Colt Plunge Base Holes |
I am looking for the hole layout measurements (distance between screw holes on the base) on the colt plunge base. Can someone with a colt plunge base measure it for me? Thanks in advance. |
|
| Author: | Michaeldc [ Tue Feb 14, 2017 11:01 am ] |
| Post subject: | Re: Colt Plunge Base Holes |
Mine reads 68mm. |
|
| Author: | david farmer [ Tue Feb 14, 2017 11:27 am ] |
| Post subject: | Re: Colt Plunge Base Holes |
Chris, the hole centers on mine are a rectangle. It looks like they were shooting for 76mm x 68mm They almost got it. center of spindle seems to be deliberately set 3mm off center on 68mm side.
|
|
| Author: | Chris Ensor [ Tue Feb 14, 2017 1:32 pm ] |
| Post subject: | Re: Colt Plunge Base Holes |
david farmer wrote: Chris, the hole centers on mine are a rectangle. It looks like they were shooting for 76mm x 68mm They almost got it. center of spindle seems to be deliberately set 3mm off center on 68mm side.Thanks. That's for the plunge base correct? |
|
| Author: | david farmer [ Tue Feb 14, 2017 1:39 pm ] |
| Post subject: | Re: Colt Plunge Base Holes |
  Sorry. didn't see plunge. That's the fixed base.
|
|
| Author: | Chris Ensor [ Tue Feb 14, 2017 2:00 pm ] |
| Post subject: | Re: Colt Plunge Base Holes |
Michaeldc wrote: Mine reads 68mm. Is this for the plunge base- 68mm square pattern? |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|