| Official Luthiers Forum! https://www.luthiersforum.com/forum/ |
|
| Pultruded Carbon Rods from LMI https://www.luthiersforum.com/forum/viewtopic.php?f=10101&t=48009 |
Page 1 of 1 |
| Author: | EddieLee [ Tue Jul 12, 2016 3:53 pm ] |
| Post subject: | Pultruded Carbon Rods from LMI |
Does anybody here use these Pultruded Carbon Rods from LMI in you necks and can you offer any tips? https://www.lmii.com/products/mostly-no ... arbon-rods |
|
| Author: | SteveSmith [ Tue Jul 12, 2016 5:38 pm ] |
| Post subject: | Re: Pultruded Carbon Rods from LMI |
I have used the 1/4" hollow tubes and also the 1/8" x 3/8" bars. I prefer the bars to the tubes but to be honest I am not using them anymore. I would probably use some if I had a neck that was too flexible but I feel that the two-way Martin truss rods I use now are sufficient. |
|
| Author: | ChuckH [ Wed Jul 13, 2016 6:30 am ] |
| Post subject: | Re: Pultruded Carbon Rods from LMI |
Check out Allred at dragonplate.com for good prices on all carbon fiber materials. Sent from my iPad using Tapatalk |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|