| Official Luthiers Forum! https://www.luthiersforum.com/forum/ |
|
| bridge making with small cnc https://www.luthiersforum.com/forum/viewtopic.php?f=10101&t=43561 |
Page 1 of 1 |
| Author: | weslewis [ Fri May 30, 2014 11:18 am ] |
| Post subject: | bridge making with small cnc |
Here is a 12 string bridge I am making which will use only 6 pins, I wanted to use ebony but with the increase size of the bridge I needed to lose some weight, so I made a 2 piece bridge with a pocket milled out on the bottom piece...and drilled a jig with the same program to glue the pieces together accuately.. |
|
| Author: | weslewis [ Sat May 31, 2014 4:15 pm ] |
| Post subject: | more fun with the cnc.. |
finished shaping bridge for the 12 string , plus cut a compensated nut for my L-00... |
|
| Author: | David Malicky [ Sun Jun 01, 2014 5:33 pm ] |
| Post subject: | Re: bridge making with small cnc |
Nice shape! |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|