| Official Luthiers Forum! https://www.luthiersforum.com/forum/ |
|
| Dual Duty https://www.luthiersforum.com/forum/viewtopic.php?f=10101&t=42609 |
Page 1 of 1 |
| Author: | DannyV [ Sun Feb 02, 2014 12:11 pm ] |
| Post subject: | Dual Duty |
I just discovered that my bridge pin reamer, Stu Mac I think, is the perfect size to ream off any excess finish around tuner holes for, in this case, threaded Gotoh bushings. .310 I think. Best tool I've found for the task. |
|
| Author: | Frank Ford [ Sun Feb 02, 2014 12:26 pm ] |
| Post subject: | Re: Dual Duty |
Yup, my favorite, too - I generally reach for the five degree one, so it doesn't cut to far down the hole. The fat end of bridge pin reamers is always sharp, too. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|