| Official Luthiers Forum! https://www.luthiersforum.com/forum/ |
|
| lamminate bit help https://www.luthiersforum.com/forum/viewtopic.php?f=10101&t=42179 |
Page 1 of 1 |
| Author: | wbergman [ Sat Dec 14, 2013 12:02 pm ] |
| Post subject: | lamminate bit help |
I am looking to transfer from plastic template to 3/4" MDF to build up molds. I have a 1/4" laminate trimmer. Is there a trimmer bit with 1" of cutting depth and a smooth or bearing guide to follow the pattern? |
|
| Author: | emoney [ Sat Dec 14, 2013 12:59 pm ] |
| Post subject: | Re: lamminate bit help |
Tons of them, just about anywhere you would shop for router bits. Here's a Woodcraft example; http://www.woodcraft.com/Product/200186 ... 14-SH.aspx But that's just one of many. Up spiral, down spiral, flush trim they're everywhere!!!!! Gyaaahhhh!!! |
|
| Author: | wbergman [ Sat Dec 14, 2013 2:24 pm ] |
| Post subject: | Re: lamminate bit help |
Thanks. I thought they should be everywhere, but my searches were incompetent. |
|
| Author: | Alex Kleon [ Sat Dec 14, 2013 2:32 pm ] |
| Post subject: | Re: lamminate bit help |
Like Eric said, there are many to be had, but make sure that you cut within 1/8" of your line, and take a couple of passes to get the bearing to the template. And wear a mask! Alex |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|