| Official Luthiers Forum! https://www.luthiersforum.com/forum/ |
|
| Source for rabbeting bit https://www.luthiersforum.com/forum/viewtopic.php?f=10101&t=18324 |
Page 1 of 1 |
| Author: | Laurent Brondel [ Sat Aug 09, 2008 8:32 am ] |
| Post subject: | Source for rabbeting bit |
I'm looking for a replacement bit (SM binding set), 1/4" shank, .925" diameter, .250" inside bearing diameter. No luck finding the thing locally or online, at over $40 I find SM overpriced… Any supplier? |
|
| Author: | JimWomack [ Sat Aug 09, 2008 12:57 pm ] |
| Post subject: | Re: Source for rabbeting bit |
Hi Laurent, I struggled with this same problem week. Knocked my laminate trimmer off the bench, ruined the StewMac bit. I have a Frued 1" rabbeting bit laying around but the bearing shaft was too short for the SM bearings. Tracy provided a link for rabbeting bits that work with the LMI bearing set... maybe they'd work with the StewMac bearings if you used some kind of center bushing. Here's the thread: http://www.luthiersforum.com/forum/viewtopic.php?f=10101&t=18272 As for me, I broke down and bought a replacement StewMac bit. A little pricey at $51 including shipping, but I've got 2 boxes that need binding, so I couldn't wait. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|