Official Luthiers Forum!
http://www.luthiersforum.com/forum/

Making the most out of the Robert O'Brien Neck Angle Jig
http://www.luthiersforum.com/forum/viewtopic.php?f=10146&t=48931
Page 1 of 1

Author:  ericschaeferguitars [ Sun Jan 29, 2017 1:23 pm ]
Post subject:  Making the most out of the Robert O'Brien Neck Angle Jig

This video is about a jig that I absolutely love! The Robert O'brien Mortise and Tenon Jig (AKA Neck Angle Jig).
There are a lot of things about using this jig, however, that trip alot of people up. So with this video, I'm going to walk through my process for using the jig, and address some of the common problems that people have. I will also show you how to hook up a shopvac to the jig so you don't get wood chips thrown at your face!


Author:  Robbie O'Brien [ Fri Feb 17, 2017 11:00 am ]
Post subject:  Re: Making the most out of the Robert O'Brien Neck Angle Jig

Nice video Eric and I like the modifications. [clap]

Author:  ericschaeferguitars [ Wed Mar 15, 2017 2:10 pm ]
Post subject:  Re: Making the most out of the Robert O'Brien Neck Angle Jig

Robbie O'Brien wrote:
Nice video Eric and I like the modifications. [clap]


Thanks Robbie! I've been using it for years. I have you to thank for it!

Author:  rlrhett [ Mon Apr 03, 2017 11:02 pm ]
Post subject:  Re: Making the most out of the Robert O'Brien Neck Angle Jig

Robbie, do you sell plans for this jig? I thought I had read that people were buying plans from you. I'm not up to buying it pre-made from LMI, but it doesn't seem fair to just copy it if you are selling plans.

Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/