| Official Luthiers Forum! http://www.luthiersforum.com/forum/ |
|
| epiphone sheraton: nut issue http://www.luthiersforum.com/forum/viewtopic.php?f=10137&t=51475 |
Page 1 of 1 |
| Author: | Paul Eisen [ Thu Jan 17, 2019 2:56 pm ] |
| Post subject: | epiphone sheraton: nut issue |
Hi all, I recently bought an Epiphone Sheraton, and have done all the things you expect to do with an inexpensive production guitar: fret dress, replace bad switches. But the nut. I was planning to cut a bone nut in any case, but the production nut sits oddly on the neck. I am new to electrics, and Epiphones in general. But is it normal for the nut to be twice the width of the landing it sits on? Next question: when i cut the new nut, should I 1) copy the existing one, and put a shim underneath where the space is now, or 2) get a file and drop the entire landing down to the lowest point, and carve a taller nut, or 3) create a nut with a base shaped like the existing landing? Thanks! --Paul |
|
| Author: | B. Howard [ Thu Jan 17, 2019 3:11 pm ] |
| Post subject: | Re: epiphone sheraton: nut issue |
I do not think that is the original nut. For the new nut I might take option 4, make a new nut the width of the existing landing. |
|
| Author: | Rodger Knox [ Thu Jan 17, 2019 3:57 pm ] |
| Post subject: | Re: epiphone sheraton: nut issue |
I agree with Brian, that's not the original nut. Make a new one and match the width and angle of the existing landing. |
|
| Author: | Chris Pile [ Thu Jan 17, 2019 4:29 pm ] |
| Post subject: | Re: epiphone sheraton: nut issue |
Not original... And I notice the bottom shelf is angled. You'll need a Martin style nut blank, or cut one from bone being careful to match the angle on the bottom. |
|
| Author: | Paul Eisen [ Thu Jan 17, 2019 10:28 pm ] |
| Post subject: | Re: epiphone sheraton: nut issue |
Thanks, folks. Option 4 it shall be. —Paul |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|