Official Luthiers Forum!
http://www.luthiersforum.com/forum/

Pickup wiring
http://www.luthiersforum.com/forum/viewtopic.php?f=10123&t=49594
Page 1 of 1

Author:  Gabe61 [ Fri Jul 28, 2017 4:35 pm ]
Post subject:  Pickup wiring

Hello and thanks for having me! I'm a little ways into my first bass build and have some questions about the pickups. I bought some cheap amazon pickups and would like to wire four of them each to their own volume pot then straight to the input jack. Would anybody out there be willing to draw up a diagram for me?Image


Sent from my iPhone using Tapatalk

Author:  GourmetSaint [ Sat Jul 29, 2017 5:34 pm ]
Post subject:  Re: Pickup wiring

Where are the ground wires? Can't see them in the pics.

Sent from my SM-G920I using Tapatalk

Author:  Gabe61 [ Sun Jul 30, 2017 7:42 pm ]
Post subject:  Re: Pickup wiring

GourmetSaint wrote:
Where are the ground wires? Can't see them in the pics.

Sent from my SM-G920I using Tapatalk

It only has two wires Image


Sent from my iPhone using Tapatalk

Author:  Freeman [ Sun Jul 30, 2017 9:05 pm ]
Post subject:  Re: Pickup wiring

Do you want switching or are you going to just turn the volume down/off? Any tone control?

If you PM me an e-mail address I can scan a simple wiring diagram from a Jazz Bass and send it to you

Author:  Gabe61 [ Mon Jul 31, 2017 2:15 pm ]
Post subject:  Re: Pickup wiring

Freeman wrote:
Do you want switching or are you going to just turn the volume down/off? Any tone control?

If you PM me an e-mail address I can scan a simple wiring diagram from a Jazz Bass and send it to you


No tone control. Seems how it's gonna have four pickups I'm going to control the tone via pickup selection. No toggles just four volumes. Not to worried about spam here so my email is gabe61willys@gmail.com


Sent from my iPhone using Tapatalk

Author:  Gabe61 [ Mon Jul 31, 2017 2:16 pm ]
Post subject:  Re: Pickup wiring

I've seen jazz diagrams, can I just double that and omit the tone control?


Sent from my iPhone using Tapatalk

Author:  Freeman [ Mon Jul 31, 2017 2:58 pm ]
Post subject:  Re: Pickup wiring

Gabe61 wrote:
I've seen jazz diagrams, can I just double that and omit the tone control?


Sent from my iPhone using Tapatalk


That is what I was going to suggest. The hot wire from each pickup goes to the center terminal of its pot (the sliding contact), one end of the pot is grounded and the other (top) end is in parallel with each of the other pots to the jack. If you take the pickup wire to the top end like many single pickup guitars you'll have a problem if you turn any pot to zero - it will kill all of them. Eliminate the tone circuit.

The J-bass diagrams that I have seen all use 250K pots - that is the normal value used with single coil pickup. Most humbuckers are happier with 500K (I assume thats true for basses too) and make sure you get "audio" or log taper instead of linear.

Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/