Official Luthiers Forum!
http://www.luthiersforum.com/forum/

EZ Mold build for a OO.
http://www.luthiersforum.com/forum/viewtopic.php?f=10117&t=45026
Page 1 of 1

Author:  Linus [ Sat Jan 31, 2015 7:14 pm ]
Post subject:  EZ Mold build for a OO.

I built a mold for a OO.

3 layers of MDF.

1/2" dowels help align the two halves.

6" eye bolts with knobs hold the 2 halves together but stay out of the way of the neck and end block when it's time to clamp them to the sides.

Image

Author:  Glenn_Aycock [ Tue May 19, 2015 8:59 pm ]
Post subject:  Re: EZ Mold build for a OO.

Rather than gluing up the layers and cutting out each half (lots of sanding), if you use dowels or some other means of registering/aligning the layers, once you cut/sand/perfect the first one, you can rough cut the others on the bandsaw and use the first one as a template to finish the rest with a router and pilot bearing bit. Very little additional sanding needed. Then glue them together.

Author:  Linus [ Fri Jun 05, 2015 8:06 am ]
Post subject:  Re: EZ Mold build for a OO.

The router method would work well too. I have an random orbital spindle sander connected to dust collection. I'm pretty good with a band saw so the sanding doesn't take long at all.

Lots of ways to get from point A to point B. That one of the reasons I like this forum so much. I get to see lots of different ways to accomplish the same task and decide which works best for me.

Author:  Glenn_Aycock [ Fri Jun 05, 2015 10:41 am ]
Post subject:  Re: EZ Mold build for a OO.

Agreed. I just try to avoid sanding (and routing) MDF as much as possible. Even with a dust collector, that stuff goes everywhere, and it dulls blades quickly too.


Sent from my iPhone using Tapatalk

Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/