Official Luthiers Forum!
http://www.luthiersforum.com/forum/

One Method for Milling Glued-Up Burl Rosette Rings
http://www.luthiersforum.com/forum/viewtopic.php?f=10117&t=15913
Page 1 of 1

Author:  Terry Stowell [ Fri Feb 15, 2008 10:51 am ]
Post subject:  Re: One Method for Milling Glued-Up Burl Rosette Rings

[clap] Well done Todd! Can't wait to see that one finished. Thanks for the tutorial!

Author:  Hesh [ Fri Feb 15, 2008 11:09 am ]
Post subject:  Re: One Method for Milling Glued-Up Burl Rosette Rings

Very nicely done toot ("one method") Todd! Many thanks! [clap] [clap] [clap] [clap]

Tony Soprano would be proud of the care you took when cutting up Burl Ives on a band saw........ :D

Author:  James Orr [ Sat Feb 23, 2008 4:35 pm ]
Post subject:  Re: One Method for Milling Glued-Up Burl Rosette Rings

What a beautiful rosette in waiting. It makes me a bit dissatisfied with the red abalone heart I'm getting ready to put in a redwood top [:Y:]

Author:  Mattia Valente [ Wed Apr 02, 2008 4:19 am ]
Post subject:  Re: One Method for Milling Glued-Up Burl Rosette Rings

As an alternative, I've had very good luck joining rosette blanks using the 'tent' method used for tops (masking tape). If the joint's tight, a few strips of stewmac brown masking tape will do wonders. Recently used it to make a cavity cover blank for an electric from some offcuts that were not wide enough on their own, and I needed a good grain/colour match.

Author:  Chris Paulick [ Mon Sep 22, 2008 8:06 pm ]
Post subject:  Re: One Method for Milling Glued-Up Burl Rosette Rings

Great tutorial as usual Todd.

Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/