| Official Luthiers Forum! http://www.luthiersforum.com/forum/ |
|
| Vacuum fixture making a vacuum fixture http://www.luthiersforum.com/forum/viewtopic.php?f=10106&t=37819 |
Page 1 of 1 |
| Author: | Sheldon Dingwall [ Mon Sep 24, 2012 8:27 pm ] |
| Post subject: | Vacuum fixture making a vacuum fixture |
This impressed me today. I needed a pair of outboard vacuum supports to hold neck fixtures on my main vacuum table. Milled the parts this far with just vacuum hold down - no index pins. I had enough surface area that the workpiece held solid slotting with a 1/2" cutter. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|