| Official Luthiers Forum! http://www.luthiersforum.com/forum/ |
|
| Dimensional ebony suppliers http://www.luthiersforum.com/forum/viewtopic.php?f=10102&t=10582 |
Page 1 of 1 |
| Author: | old man [ Sat Jan 27, 2007 3:56 pm ] |
| Post subject: | |
Michael, Woodcraft has 3/4 X 3 x 24". Gaboon ebony Ron |
|
| Author: | Jim Kirby [ Sun Jan 28, 2007 1:43 am ] |
| Post subject: | |
Maybe Larry Davis at galleryhardwoods.com? |
|
| Author: | npalen [ Sun Jan 28, 2007 4:38 am ] |
| Post subject: | |
Ebony If you can't find any from the OLF sponsors. Nelson |
|
| Author: | GD Armstrong [ Sun Jan 28, 2007 6:19 am ] |
| Post subject: | |
In Portland, last time I was at Crosscut, out on Front Ave by the docks, they had a stack in the back room. There's also Moxon on NW 21st, they sometimes have interesting exotics. GD |
|
| Author: | npalen [ Sun Jan 28, 2007 1:16 pm ] |
| Post subject: | |
Michael--Sorry, I forgot that you were looking in the Washington/Oregon area. Eisenbrand is in Torrance, CA. Nelson |
|
| Author: | fryovanni [ Mon Jan 29, 2007 5:34 am ] |
| Post subject: | |
Michael, I think Crosscut still has that little stack of Ebony in the back as mentioned. Rockler out near the Bevertoon Freddys has a few pieces in a bin(I can't recall if it was 1" or 3/4"). I think Woodcrafters over near MLK and just north of Burnside had a couple pieces. If you are willing to use Blackwood instead of Ebony Woodcrafters did have a couple pieces on the shelf. Good Luck! Rich |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|