| Official Luthiers Forum! http://www.luthiersforum.com/forum/ |
|
| Source for blades in LMI rosette cutter for drill press? http://www.luthiersforum.com/forum/viewtopic.php?f=10101&t=56142 |
Page 1 of 1 |
| Author: | guitarjtb [ Sat Dec 23, 2023 11:50 pm ] |
| Post subject: | Source for blades in LMI rosette cutter for drill press? |
I bought a used LMI rosette cutter for the drill press a while back. I need some replacement blades, but can no longer find them at LMI. Does anyone have a source for the blades. Do you know if a blade is available to cut a .030" channel. The smallest blade I have cuts a 1/16" channel. |
|
| Author: | guitarjtb [ Tue Dec 26, 2023 9:02 am ] |
| Post subject: | Re: Source for blades in LMI rosette cutter for drill press? |
Anyone? |
|
| Author: | Clay S. [ Tue Dec 26, 2023 10:50 am ] |
| Post subject: | Re: Source for blades in LMI rosette cutter for drill press? |
I assume this is the tool you have: https://www.youtube.com/watch?v=3aGMy0nXp6U For something as thin as .030" You might regrind something like an old pocket knife blade or even a Stanley knife blade. For thicker inserts you could buy a length of tool steel and regrind it to various widths. Unless you are doing multiple rosettes to the same dimensions that tool looks like a PITA to set up and test (O'Brien seemed to indicate as much at the end of the video). |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|