Official Luthiers Forum!
http://www.luthiersforum.com/forum/

Drum Sander Conveyer...
http://www.luthiersforum.com/forum/viewtopic.php?f=10101&t=53698
Page 1 of 1

Author:  meddlingfool [ Sat Nov 21, 2020 6:44 pm ]
Post subject:  Drum Sander Conveyer...

Anyone know how to fix this?

Image


Sent from my iPhone using Tapatalk

Author:  Ken Lewis [ Sat Nov 21, 2020 7:22 pm ]
Post subject:  Re: Drum Sander Conveyer...

Epoxy, couple flat cauls and clamps. You'll need to remove to do a proper job I would think.
Then order a new one for when it goes kaput again. :)

Author:  meddlingfool [ Sat Nov 21, 2020 8:06 pm ]
Post subject:  Re: Drum Sander Conveyer...

For some reason CA didn’t work, lol. Maybe epoxy would...

Author:  doncaparker [ Sat Nov 21, 2020 8:18 pm ]
Post subject:  Re: Drum Sander Conveyer...

I would “fix” it with a purchase of a new one from Klingspor.

Author:  meddlingfool [ Sat Nov 21, 2020 10:35 pm ]
Post subject:  Re: Drum Sander Conveyer...

Yes, I think that’s the best duct tape too...

Author:  Clay S. [ Sat Nov 21, 2020 10:48 pm ]
Post subject:  Re: Drum Sander Conveyer...

You might try sanding both sides of the seam lightly and using the clear gorilla tape.

Author:  meddlingfool [ Sun Nov 22, 2020 3:41 am ]
Post subject:  Re: Drum Sander Conveyer...

I think I'm going to go from ffix it yourself poorly and wreck your project straight into replace it with a new one dumba** with no intervening steps...

Author:  Clay S. [ Sun Nov 22, 2020 11:47 am ]
Post subject:  Re: Drum Sander Conveyer...

meddlingfool wrote:
I think I'm going to go from ffix it yourself poorly and wreck your project straight into replace it with a new one dumba** with no intervening steps...


As a professional who really needs the machine that is often your best option. You may even want to keep a spare [:Y:]

Author:  Alain Lambert [ Sun Nov 22, 2020 5:19 pm ]
Post subject:  Re: Drum Sander Conveyer...

I would use a more flexible glue than epoxy. Possibly polyurethane glue.

Author:  windsurfer [ Sun Nov 22, 2020 8:57 pm ]
Post subject:  Re: Drum Sander Conveyer...

I glued mine with e6000, a flexible silicone adhesive. It lasted until the replacement arrived from Klingspoor.

Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/