Official Luthiers Forum! http://www.luthiersforum.com/forum/ |
|
Delta drum sander repair question... http://www.luthiersforum.com/forum/viewtopic.php?f=10101&t=49829 |
Page 1 of 1 |
Author: | meddlingfool [ Wed Oct 18, 2017 4:31 pm ] |
Post subject: | Delta drum sander repair question... |
Does anyone know how to adjust the conveyor to be level with the drum? Mine is now sanding .015 more on the inner edge than on the outer, which is too much to live with... |
Author: | Clinchriver [ Wed Oct 18, 2017 4:42 pm ] |
Post subject: | Re: Delta drum sander repair question... |
My performax you adjust/level the drum to the conveyer it as a couple of set screws and leveling screws, its finicky but easy to adjust |
Author: | bobgramann [ Wed Oct 18, 2017 5:27 pm ] |
Post subject: | Re: Delta drum sander repair question... |
http://pdfstream.manualsonline.com/9/9d ... 2d66de.pdf Go to page 12 |
Author: | kencierp [ Wed Oct 18, 2017 5:27 pm ] |
Post subject: | Re: Delta drum sander repair question... |
http://pdfstream.manualsonline.com/9/9d ... 2d66de.pdf Page 11 |
Author: | meddlingfool [ Wed Oct 18, 2017 5:30 pm ] |
Post subject: | Re: Delta drum sander repair question... |
Yahtzee, thanks folks! |
Author: | Mike Lindstrom [ Thu Oct 19, 2017 7:08 pm ] |
Post subject: | Re: Delta drum sander repair question... |
I've always taken a piece of ply or mdf and run it through. Then it's parallel and use it as a sled. |
Author: | meddlingfool [ Fri Oct 20, 2017 1:09 pm ] |
Post subject: | Re: Delta drum sander repair question... |
I grew quite sick of sleds... |
Page 1 of 1 | All times are UTC - 5 hours |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |