| Official Luthiers Forum! http://www.luthiersforum.com/forum/ |
|
| Super Simple Speedy Sunday X Brace Notching System... http://www.luthiersforum.com/forum/viewtopic.php?f=10101&t=45045 |
Page 2 of 2 |
| Author: | SteveSmith [ Tue Oct 24, 2017 1:12 pm ] |
| Post subject: | Re: Super Simple Speedy Sunday X Brace Notching System... |
Wow, you guys are fancy. I just set the angle on an Incra miter gauge, cut slightly under size on the table saw then get the precise fit with a chisel. Only takes a few minutes. Since every guitar I make is slightly different it doesn't make sense to build a jig IMO. |
|
| Author: | Colin North [ Tue Oct 24, 2017 3:48 pm ] |
| Post subject: | Re: Super Simple Speedy Sunday X Brace Notching System... |
kencierp wrote: Here's an adjustable "X"notch jig that does not require power tools -- just a razor saw. http://www.kennethmichaelguitars.com/Xb ... guide.html Neat!! |
|
| Author: | fingerstyle1978 [ Tue Oct 24, 2017 5:18 pm ] |
| Post subject: | Re: Super Simple Speedy Sunday X Brace Notching System... |
meddlingfool wrote: I know my tablesaw sees a lot of use. Enough to buy one for each end of the shop... Agreed and can occasionally double as another work/clamping surface. The best jig for me yet though is definitely the powered fret slotting jig with my table saw. What a time saver. |
|
| Author: | meddlingfool [ Tue Oct 24, 2017 6:19 pm ] |
| Post subject: | Re: Super Simple Speedy Sunday X Brace Notching System... |
I hardly use my tablesaw for anything anymore. I got a Laguna SUV which handles straight cut operations. The tablesaw now has dados as a permanent feature, which is used for lapping the x's and cutting the t rod slot. All I need to do is adjust height depending on which job is going on... |
|
| Page 2 of 2 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|