Official Luthiers Forum!
http://www.luthiersforum.com/forum/

Reducing 6" S&D pipe to 4" flex for dust collection
http://www.luthiersforum.com/forum/viewtopic.php?f=10101&t=41006		 Page 1 of 1
Author:  sprouseod [ Wed Jul 31, 2013 5:06 pm ]
Post subject:  Reducing 6" S&D pipe to 4" flex for dust collection
I am looking at putting in an oneida cyclone system. All my (machine)ports are 4" and I plan to run a 4" flex to the 6" branches of the main vac into each machine. What is the best way to reduce it down to the 4" flex hose?

Thanks
Richard
Author:  Rodger Knox [ Wed Jul 31, 2013 5:07 pm ]
Post subject:  Re: Reducing 6" S&D pipe to 4" flex for dust collection
A 4"x6" reducer? duh
Author:  DannyV [ Wed Jul 31, 2013 5:12 pm ]
Post subject:  Re: Reducing 6" S&D pipe to 4" flex for dust collection
Rodger Knox wrote:
A 4"x6" reducer? duh

X 2 Ha Ha

Keep your 6" runs as long as possible an get as close to the machine with it. Little or no 4" is best.
Author:  sprouseod [ Wed Jul 31, 2013 5:24 pm ]
Post subject:  Re: Reducing 6" S&D pipe to 4" flex for dust collection
Sorry, it wasn't clear, 4" ports on the machines. :D
Author:  sprouseod [ Thu Aug 01, 2013 12:03 pm ]
Post subject:  Re: Reducing 6" S&D pipe to 4" flex for dust collection
Todd when you say " convert". Do you mean using a 5" adapter in the 4" port or structurally modifying the port on the machines?
Author:  B. Howard [ Thu Aug 01, 2013 7:15 pm ]
Post subject:  Re: Reducing 6" S&D pipe to 4" flex for dust collection
Make sure you ground that S&D stuff.
Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/