Official Luthiers Forum! http://www.luthiersforum.com/forum/
Madinter truss rod installation http://www.luthiersforum.com/forum/viewtopic.php?f=10101&t=38010	Page 1 of 1

---

Author:	PeterF [ Wed Oct 17, 2012 2:03 pm ]
Post subject:	Madinter truss rod installation
I can't find any information about these truss rods or which way up to install them. Are they the same as the martin style ones with the taped side down? Should I epoxy it in? http://www.madinter.com/b2c/index.php?p ... =0&ref=AA1

---

Author:	PeterF [ Thu Oct 18, 2012 2:38 am ]
Post subject:	Re: Madinter truss rod installation
That's what it says for the martin truss rods, but apart from the small radius where the aluminium has been bent to make the U channel, this one is flat on both sides, with one side solid and the other covered with tape.

---

Author:	PeterF [ Thu Oct 18, 2012 10:11 am ]
Post subject:	Re: Madinter truss rod installation
Thanks

---

Page 1 of 1	All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/