| Official Luthiers Forum! http://www.luthiersforum.com/forum/ |
|
| Deflection testing http://www.luthiersforum.com/forum/viewtopic.php?f=10101&t=37836 |
Page 1 of 1 |
| Author: | violinvic [ Wed Sep 26, 2012 1:28 pm ] |
| Post subject: | Deflection testing |
I want to start doing deflection testing on my tops. Would someone please describe, in detail, the process that you use? Pals, Vic. |
|
| Author: | meddlingfool [ Wed Sep 26, 2012 1:39 pm ] |
| Post subject: | Re: Deflection testing |
Heres my way Two angle iron/aluminum supports, placed exactly 18" apart. Make sure the tops of the bars are flat in line with each other. Draw an x from corner to corner. Over the center of the x place your dial gauge. Place top over angle iron Add weight Measure deflection |
|
| Author: | Dave Stewart [ Wed Sep 26, 2012 1:48 pm ] |
| Post subject: | Re: Deflection testing |
Vic, a couple of threads just recently talked about this. (You're not talking about violins, are you??) viewtopic.php?f=10101&t=37774&hilit=Deflection viewtopic.php?f=10101&t=37822&hilit=Deflection |
|
| Author: | violinvic [ Wed Sep 26, 2012 2:39 pm ] |
| Post subject: | Re: Deflection testing |
I should stated that this is for guitar tops. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|