| Official Luthiers Forum! http://www.luthiersforum.com/forum/ |
|
| neck block taper http://www.luthiersforum.com/forum/viewtopic.php?f=10101&t=36827 |
Page 1 of 1 |
| Author: | segovia [ Sun Jun 17, 2012 2:00 pm ] |
| Post subject: | neck block taper |
Hi If my plan calls for neck block depth of 95mm do I make it slightly over to all for a taper on the face that will attach to the back ? How do you calculate the taper or do I just make it all about 3mm over and take it off with the radius dish ? J |
|
| Author: | John Arnold [ Sun Jun 17, 2012 7:31 pm ] |
| Post subject: | Re: neck block taper |
Quote: do I just make it all about 3mm over and take it off with the radius dish ? That is my approach, though I don't use the dish. After gluing he block to the sides, I taper it with hand planes and a sanding block. |
|
| Author: | segovia [ Mon Jun 18, 2012 1:44 am ] |
| Post subject: | Re: neck block taper |
Thanks =, I am going to try this approach to gate the correct taper and radius There is no mention of what the starting dimensions are, I'll add the 3mm http://gicl.cs.drexel.edu/people/sevy/l ... ining.html Regards J |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|