I made one similar by copying it from the illustration and using their free instruction sheet for it. http://www.stewmac.com/freeinfo/Jigs/i-4043.html
Good Luck
![[:Y:]](./images/smilies/smiley20.gif "Thumbs Up")
| Official Luthiers Forum! http://www.luthiersforum.com/forum/ |
|
| making plexiglass fixture http://www.luthiersforum.com/forum/viewtopic.php?f=10101&t=36606 |
Page 1 of 1 |
| Author: | Tai Fu [ Sat May 26, 2012 10:51 am ] |
| Post subject: | making plexiglass fixture |
I want to make some fixtures out of plexiglass, but was wondering are there any plans out there for various jigs like the bridge saddle slot routing jig that Stewmac sells (which allows you to route saddle slots on the guitar)? |
|
| Author: | Ron Belanger [ Sat May 26, 2012 11:15 am ] |
| Post subject: | Re: making plexiglass fixture |
I made one similar by copying it from the illustration and using their free instruction sheet for it. http://www.stewmac.com/freeinfo/Jigs/i-4043.html Good Luck
|
|
| Author: | Shaw [ Sat May 26, 2012 7:11 pm ] |
| Post subject: | Re: making plexiglass fixture |
You can make theses same jigs out of plywood or mdf too. |
|
| Author: | Tai Fu [ Sat May 26, 2012 7:52 pm ] |
| Post subject: | Re: making plexiglass fixture |
Shaw wrote: You can make theses same jigs out of plywood or mdf too. Yes, but the reason I'd like to use plexiglass is so I can see through them and be able to see what I am doing. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|