| Official Luthiers Forum! http://www.luthiersforum.com/forum/ |
|
| HELP- armrest issues http://www.luthiersforum.com/forum/viewtopic.php?f=10101&t=35394 |
Page 1 of 1 |
| Author: | Chris Ensor [ Tue Feb 14, 2012 9:10 am ] |
| Post subject: | HELP- armrest issues |
I am doing an armrest (koa) on my current build. It was looking great until finish. I was leveling pore fill on the radial cocobolo on the top around the armrest and sanded just a smidge too much. Now my nice .010 black purfling line around the armrest has revealed more and apparently has rolled over a bit. There isn't a gap, but instead the purf line is about .030 now. I don't like the way this looks. Any suggestions? I am hoping someone might have an idea other than rip the armrest laminate off and try again (again). Thanks. |
|
| Author: | Colin North [ Tue Feb 14, 2012 4:36 pm ] |
| Post subject: | Re: HELP- armrest issues |
Picture may help. |
|
| Author: | woody b [ Tue Feb 14, 2012 5:28 pm ] |
| Post subject: | Re: HELP- armrest issues |
I don't do bevels so I may be way off........but..........the armrest area of the guitar obviously looks different than the rest of the edge. Can you sand it until it just kinda blends from a .010" purf into a .030" purf, then back to .010"? I know it may bother you most people (including me) would think it was cool. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|