| Official Luthiers Forum! http://www.luthiersforum.com/forum/ |
|
| Question regarding "no load" abrasives http://www.luthiersforum.com/forum/viewtopic.php?f=10101&t=35072 |
Page 1 of 1 |
| Author: | Beth Mayer [ Sun Jan 22, 2012 8:19 pm ] |
| Post subject: | Question regarding "no load" abrasives |
I think I remember seeing that Searate-treated sand paper can cause problems with finish adhesion if using waterborne finish. Is this true? What abrasives do you think are okay and not okay to use to prep for finishing? I will be using Target waterborne on the current build. Thanks, beth |
|
| Author: | Ti-Roux [ Sun Jan 22, 2012 9:22 pm ] |
| Post subject: | Re: Question regarding "no load" abrasives |
I used sialac from Sia, and used EM6000... had no problem yet. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|