Official Luthiers Forum!
http://www.luthiersforum.com/forum/

0000 Waist Size?
http://www.luthiersforum.com/forum/viewtopic.php?f=10101&t=34289
Page 1 of 1

Author:  chiptheshrink [ Fri Nov 18, 2011 5:04 pm ]
Post subject:  0000 Waist Size?

I was just given a Martin IR 0000/M size rim to build with, no top or back yet, and it looks to me like it might have "spread out" a little at the waist (I know it has happened to me over time too.) I was wondering if anyone has that dimension. The Martin website has the bout sizes, but now the waist. If it needs narrowing a bit I can pull it in a tad, it just looks a little chubby right now. Thanks!

Author:  TonyKarol [ Fri Nov 18, 2011 5:10 pm ]
Post subject:  Re: 0000 Waist Size?

Not sure, but i would put an OM shape beside it and keep the curves the same .. then you get what you get ...

Author:  woody b [ Fri Nov 18, 2011 5:28 pm ]
Post subject:  Re: 0000 Waist Size?

Waist on a Martin 0000/J/M is 9 3/4"

Author:  chiptheshrink [ Sat Nov 19, 2011 8:19 pm ]
Post subject:  Re: 0000 Waist Size?

Thanks, I figured I could count on the folks here!!!
Chip Hunter

Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/