Official Luthiers Forum! http://www.luthiersforum.com/forum/ |
|
Double X-Bracing, Coupled or Not? http://www.luthiersforum.com/forum/viewtopic.php?f=10101&t=33579 |
Page 1 of 1 |
Author: | DarrenFiggs [ Mon Sep 19, 2011 3:36 pm ] |
Post subject: | Double X-Bracing, Coupled or Not? |
For those of you who use double x-bracing, is the lower x-brace coupled to the top x-brace with lap joints where the two intersect and then extended to the sides? Or do you just butt the lower brace against the top brace and then butt a finger brace up against the other side? How does coupling the two change the response of the top? |
Author: | ChuckB [ Mon Sep 19, 2011 4:48 pm ] |
Post subject: | Re: Double X-Bracing, Coupled or Not? |
I just butt the lower x against the upper, and line up the finger brace on the other side. Chuck |
Author: | weslewis [ Mon Sep 19, 2011 6:00 pm ] |
Post subject: | Re: Double X-Bracing, Coupled or Not? |
Here is how I did one on a dred, haven't got the guitar finished yet so I don't yet know how it will sound...I thought this bracing scheme looked pretty cool, I think its done on some old Gibson's... |
Author: | truckjohn [ Mon Sep 19, 2011 6:02 pm ] |
Post subject: | Re: Double X-Bracing, Coupled or Not? |
I suppose it depends on what you want to do.... If you do couple it - you will have to decide on how to deal with the additional stiffness.... If you don't - you might end up wondering how much lighter you could have built it if you had.... or maybe it will come out fine like many others have.... I didn't couple the last one and the lower X was really lightly built... It sounds great, but it's got a couple funny sinky marks in the lower bout... Is it from coupling or not coupling the bottom X to the upper X or is it from too wide of an X or not enough bridge overlap... Not real sure... but the solution is probably within that set of things.... I will have to decide what to do different on the next one... I am leaning towards a narrower X angle.... but I am still chewing it over in my head... Thanks |
Author: | truckjohn [ Tue Sep 20, 2011 6:58 am ] |
Post subject: | Re: Double X-Bracing, Coupled or Not? |
Just for reference - here's the bracing I was talking about... It's a J45 plantilla (Dread) Looing back at my bracing pix, the top sinkys are in the exact place where the lower X doesn't intersect the main X.... It might be worth running the lower X into the upper X - even if it's feathered down pretty thin where they hit.... Attachment: J45 Build 40.JPG
|
Author: | DarrenFiggs [ Tue Sep 20, 2011 4:41 pm ] |
Post subject: | Re: Double X-Bracing, Coupled or Not? |
Thanks for the comments and photos! Yes, I think coupling them might make the top really stiff. Perhaps they might work against one another. I'll try butting them up against one another on my next one. Thanks! |
Page 1 of 1 | All times are UTC - 5 hours |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |