| Official Luthiers Forum! http://www.luthiersforum.com/forum/ |
|
| Brace wood advice http://www.luthiersforum.com/forum/viewtopic.php?f=10101&t=32505 |
Page 1 of 1 |
| Author: | roby [ Sat Jun 11, 2011 5:18 am ] |
| Post subject: | Brace wood advice |
Hello all, when i built my first guitar i used sawn bracewood frim lmi ,for the next one i thought i'd try some split wood so i ordered some from alaska specialty woods along with a couple of very nice sitka tops.My question is what is the best way to proscess this into brace blanks? they have three sawn sides and one split side ,do i use the split side as a reference or the sawn side?,they are about 25mm thick by the way, i've posted a couple of pictures aswell .Thanks all Roby |
|
| Author: | Andy Birko [ Sat Jun 11, 2011 7:14 am ] |
| Post subject: | Re: Brace wood advice |
I usually just joint the split face, square up one side and off to the table saw. |
|
| Author: | Tom West [ Sat Jun 11, 2011 9:09 am ] |
| Post subject: | Re: Brace wood advice |
Concur with Andy...! Tom |
|
| Author: | roby [ Sun Jun 12, 2011 5:32 am ] |
| Post subject: | Re: Brace wood advice |
Thanks for the replies guys.Roby |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|