Official Luthiers Forum! http://www.luthiersforum.com/forum/ |
|
1/2 in crank neck chisel 4.5in blade http://www.luthiersforum.com/forum/viewtopic.php?f=10101&t=31866 |
Page 1 of 1 |
Author: | ernie [ Sat Apr 16, 2011 10:46 am ] |
Post subject: | 1/2 in crank neck chisel 4.5in blade |
I have a long handled /blade crank neck buck bros chisel. But I am looking for one with a 4 1/2in length blade. These are hard to find, anyone out there know of a good source for these chisels ?? thanks |
Author: | Kent Chasson [ Sat Apr 16, 2011 12:07 pm ] |
Post subject: | Re: 1/2 in crank neck chisel 4.5in blade |
Not exactly a crank neck but close and with a long blade: http://www.japanwoodworker.com/dept.asp ... t_id=12798 |
Author: | ernie [ Sat Apr 16, 2011 12:15 pm ] |
Post subject: | Re: 1/2 in crank neck chisel 4.5in blade |
Sorry, long handled one too hard to control for me . Looking for blade that is 4 ,1/2in long . Just e- mailed traditional woodworker on the henry taylor ones but they are out of stock currently. Have bought a lot of tools from japan woodworker . Great tools. |
Author: | Pat Foster [ Sun Apr 17, 2011 8:55 am ] |
Post subject: | Re: 1/2 in crank neck chisel 4.5in blade |
The blade on the 16mm size of these is about 5". http://www.leevalley.com/US/wood/page.a ... 41539&ap=1 Pat |
Author: | ernie [ Sun Apr 17, 2011 12:29 pm ] |
Post subject: | Re: 1/2 in crank neck chisel 4.5in blade |
thanks pat, todd , sold all my small sledges, anvil /logging tools/ saws/ wedges/axes etc. after my second back surgery last sept.. Now I buy stuff instead it/s easier for me . |
Page 1 of 1 | All times are UTC - 5 hours |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |