| Official Luthiers Forum! http://www.luthiersforum.com/forum/ |
|
| Woolson Neck Jig parts...where are you finding them? http://www.luthiersforum.com/forum/viewtopic.php?f=10101&t=29541 |
Page 1 of 1 |
| Author: | Bobby M [ Mon Oct 18, 2010 2:45 pm ] |
| Post subject: | Woolson Neck Jig parts...where are you finding them? |
I've been to 3 separate home improvement stores, Fastenal and have searched the internet. Having trouble finding the individual items for the Lexan 3/8" x 8' x 10", all the 1/2" 13unc parts, and the piano hinge. Any one that has built this from the OLF plans care to share where you sourced these materials? Thanks! |
|
| Author: | RustySP [ Mon Oct 18, 2010 3:40 pm ] |
| Post subject: | Re: Woolson Neck Jig parts...where are you finding them? |
Sometimes the small old-time corner hardware store will be the place to go when the big stores don't have what you want. Go here for 3/8" polycarbonate plate: http://www.onlinemetals.com/merchant.cf ... op_cat=181 |
|
| Author: | TonyKarol [ Mon Oct 18, 2010 3:50 pm ] |
| Post subject: | Re: Woolson Neck Jig parts...where are you finding them? |
Lexan and the like you can find at most glass places .... |
|
| Author: | Bobby M [ Mon Oct 18, 2010 3:54 pm ] |
| Post subject: | Re: Woolson Neck Jig parts...where are you finding them? |
Thanks for the link. Question: Would UHMW work as well as the Lexan or Polycarbonate? It's on the same website and it about half the cost. |
|
| Author: | RustySP [ Mon Oct 18, 2010 6:02 pm ] |
| Post subject: | Re: Woolson Neck Jig parts...where are you finding them? |
UHMW has about half the strength of lexan and may flex too much, maybe. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|