| Official Luthiers Forum! http://www.luthiersforum.com/forum/ |
|
| Cutting Edge Technologies (CET)...Great Customer Service http://www.luthiersforum.com/forum/viewtopic.php?f=10101&t=28145 |
Page 1 of 1 |
| Author: | Chris aka Sniggly [ Sat Jul 10, 2010 7:17 am ] |
| Post subject: | Re: Cutting Edge Technologies (CET)...Great Customer Service |
Todd I'm curious about what you use that mill for. Great recommend BTW. Chris |
|
| Author: | Bob Garrish [ Sat Jul 10, 2010 12:49 pm ] |
| Post subject: | Re: Cutting Edge Technologies (CET)...Great Customer Service |
That's also the size of a fret slotting mill, if you run out of rosettes and the TiAlN is still holding strong |
|
| Author: | TonyFrancis [ Sat Jul 10, 2010 6:13 pm ] |
| Post subject: | Re: Cutting Edge Technologies (CET)...Great Customer Service |
- |
|
| Author: | SteveSmith [ Sat Jul 10, 2010 7:16 pm ] |
| Post subject: | Re: Cutting Edge Technologies (CET)...Great Customer Service |
Thurston Mfg. can hook you up. http://www.thurstonmfg.com/ I got a .035" 6" dia. cutting saw with a 5/8" arbor for under $50 with shipping. |
|
| Author: | Bob Garrish [ Sat Jul 10, 2010 8:04 pm ] |
| Post subject: | Re: Cutting Edge Technologies (CET)...Great Customer Service |
Edit : Better solution posted above me while I was typing! |
|
| Author: | TonyFrancis [ Sun Jul 11, 2010 2:43 am ] |
| Post subject: | Re: Cutting Edge Technologies (CET)...Great Customer Service |
- |
|
| Author: | SteveSmith [ Sun Jul 11, 2010 5:06 am ] |
| Post subject: | Re: Cutting Edge Technologies (CET)...Great Customer Service |
The one I got has 10 teeth per inch. Shape wise, it was one of the cut-off saws http://www.thurstonmfg.com/cut-off-saws.html. I explained what I was using it for and they made it and sent it to me. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|