| Official Luthiers Forum! http://www.luthiersforum.com/forum/ |
|
| Heavy handed rim sanding repair ?? http://www.luthiersforum.com/forum/viewtopic.php?f=10101&t=27811 |
Page 1 of 1 |
| Author: | segovia [ Sun Jun 13, 2010 5:06 am ] |
| Post subject: | Heavy handed rim sanding repair ?? |
Hi I used a 15 degree radius sanding stick on my OM back, I noticed that I was a little heavy on one side. I didn't think it would matter but when I did a trial fit on the back there is a noticeable gap of 1/33 for about 4 inches, it will close up but needs some pressure. I decided to glue a slim piece of mahogany to the kerf and re sand. I used super glue and now I am beginning to have second thoughts - should I sand it off and re apply with woodglue or leave it ? John |
|
| Author: | Mike Collins [ Sun Jun 13, 2010 6:46 am ] |
| Post subject: | Re: Heavy handed rim sanding repair ?? |
The CA should hold. See if it wants to lift when probed with a chisel. mc |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|