| Official Luthiers Forum! http://www.luthiersforum.com/forum/ |
|
| Advice on preparing the top rims http://www.luthiersforum.com/forum/viewtopic.php?f=10101&t=27701 |
Page 1 of 1 |
| Author: | segovia [ Sat Jun 05, 2010 3:41 pm ] |
| Post subject: | Advice on preparing the top rims |
Hi I have glued my kerf 1/32 proud and my tail and heel block is proud about the same. I have made a 28 degree sanding stick which I will use for the top, I think I am ok for the most of the body but I am unsure what it is I am working towards at the heel end. The heel is currently 90 degrees to the side as shown in the picture, do I sand this flat rather and have radius and sand in and angle so the final angle is 91.5 degrees ? |
|
| Author: | Fred Tellier [ Sat Jun 05, 2010 7:35 pm ] |
| Post subject: | Re: Advice on preparing the top rims |
Check Hesh's tutorial http://www.luthiersforum.com/forum/viewtopic.php?f=10117&t=25931 it should answer the question. Fred |
|
| Author: | segovia [ Sun Jun 06, 2010 2:30 pm ] |
| Post subject: | Re: Advice on preparing the top rims |
Many thanks Fred, the procedure looks very simple to accomplish. John |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|