| Official Luthiers Forum! http://www.luthiersforum.com/forum/ |
|
| Question on Grover Sta-tite bushing reamer size http://www.luthiersforum.com/forum/viewtopic.php?f=10101&t=27484 |
Page 1 of 1 |
| Author: | Chris aka Sniggly [ Thu May 20, 2010 6:37 pm ] |
| Post subject: | Question on Grover Sta-tite bushing reamer size |
I am about to order several sets of Grover Sta-tites from Stewmac and understand you need a bushing reamer for these tuners. What size reamer do you use? Stewmac sells a .340 and a .348 which I think in this case would be the applicable sizes. Chris |
|
| Author: | Chris aka Sniggly [ Thu May 20, 2010 7:09 pm ] |
| Post subject: | Re: Question on Grover Sta-tite bushing reamer size |
Thanks Todd |
|
| Author: | bluescreek [ Thu May 20, 2010 8:34 pm ] |
| Post subject: | Re: Question on Grover Sta-tite bushing reamer size |
I would look at a hand reamer or a tapered reamer first. Look at a machinist supplyhouse like Enco or MSC. Better tools less costly |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|