| Official Luthiers Forum! http://www.luthiersforum.com/forum/ |
|
| Slope Shoulder J45/J50/Advanced Jumbo Cases - What Works? http://www.luthiersforum.com/forum/viewtopic.php?f=10101&t=27457 |
Page 1 of 1 |
| Author: | LuthierSupplier [ Wed May 19, 2010 9:22 am ] |
| Post subject: | Re: Slope Shoulder J45/J50/Advanced Jumbo Cases - What Works? |
Todd, This is what I do...I complete the custom shop measurement, and just email it directly to Nancy, then she sends it on to her team and they respond back with something like this(these are actual measurements of one I just finished): A Neck Length 13 3/8 Ok B Body Length (Do not include strap pin) 20 Ok C Upper Bout Width (at widest point) 11 5/16 loose each side D Lower Bout Width (at widest point) 15 1/2 1/16 ompression each side E Body Depth (at bottom of guitar) 4 1/2 Ok F Overall Guitar Length (do not include strap pin) 40 ¾ Ok G Body Depth (at upper bout) 3 5/8 Ok H Overall Depth (from flat surface to top of bridge) 5 Ok I Waist Width (at narrowest point) 9 Ok J Width of Neck (at beginning of neck) 2 ¼ Ok K Width of Neck (at nut) 1 ¾ Ok L Flat surface to bottom of neck (at 12th fret) 2 3/4 This is at the 10th fret Ok L2 Flat surface to bottom of neck (at nut) 2 3/16 Ok M Flat surface to bottom of head stock ¾ Ok By the way, this fits the AME-11. Hope that helps. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|