| Official Luthiers Forum! http://www.luthiersforum.com/forum/ |
|
| Carving carbon fiber http://www.luthiersforum.com/forum/viewtopic.php?f=10101&t=27184 |
Page 1 of 1 |
| Author: | lactose [ Wed Apr 28, 2010 10:40 am ] |
| Post subject: | Carving carbon fiber |
I decide to leave about 1/8" neck material under the fingerboard, in the section that sits on top of the box. This is to give the FB extension extra strength since this is a removable neck travel guitar. After a couple of passes with the angle grinder, I was using a chisel to clean things up. At first I was avoiding the carbon fiber spars, but then I tried trimming them with the chisel. They cut like butter. That was not expected. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|