| Official Luthiers Forum! http://www.luthiersforum.com/forum/ |
|
| Neck block and tail block similar height http://www.luthiersforum.com/forum/viewtopic.php?f=10101&t=26093 |
Page 1 of 1 |
| Author: | sprouseod [ Tue Feb 16, 2010 6:02 pm ] |
| Post subject: | Neck block and tail block similar height |
I am helping a buddy build an OM in my shop. He got a little "aggressive" with the radius dish on the back. To the point where the neck and tail block are about the same height, the back is about 3 1/2" the front is about 3 1/4. My question is #1 acoustically will this matter since the top and back are close to parallel #2 I know I can change the height of the side slightly by leaving the kerfed linings a little proud. My question is can I add to the current kerfed lining or should I remove the existing and replace it? thanks Richard |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|