| Official Luthiers Forum! http://www.luthiersforum.com/forum/ |
|
| Repair '93 Taylor Bolt On Neck http://www.luthiersforum.com/forum/viewtopic.php?f=10101&t=25922 |
Page 1 of 1 |
| Author: | Ken Franklin [ Sat Feb 06, 2010 7:57 pm ] |
| Post subject: | Repair '93 Taylor Bolt On Neck |
I was doing a partial refret on a '93 Taylor Dreadnought and I noticed a rattling sound in the neck block. Then I pressed against the Taylor label and I could feel a springing action. Is this normal? I don't want to take the label off if I don't have to but is there a way to do it so that I won't destroy the label? The neck feels solid so I'm confused. The action on the guitar was very low BTW. Any advice would be helpful. |
|
| Author: | woody b [ Sat Feb 06, 2010 9:09 pm ] |
| Post subject: | Re: Repair '93 Taylor Bolt On Neck |
I'm guessing that one of the bolts is loose. I've removed labels by heating a little with a hair dryer. Just be careful not to tear it. |
|
| Author: | joe white [ Sat Feb 06, 2010 10:30 pm ] |
| Post subject: | Re: Repair '93 Taylor Bolt On Neck |
Ken, If you do end up destroying the label I have some. Just take a photo first so I can make sure the ones I have are the same. |
|
| Author: | Ken Franklin [ Sun Feb 07, 2010 1:14 am ] |
| Post subject: | Re: Repair '93 Taylor Bolt On Neck |
Thanks a lot guys. The hairdryer worked Woody. Thanks for the offer Joe. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|