| Official Luthiers Forum! http://www.luthiersforum.com/forum/ |
|
| waiting on finish to cure.... http://www.luthiersforum.com/forum/viewtopic.php?f=10101&t=24903 |
Page 1 of 1 |
| Author: | J Hewitt [ Sat Dec 05, 2009 9:05 am ] |
| Post subject: | waiting on finish to cure.... |
What are your thoughts on the minimal amount of time to wait for the EM6000 to cure before rubbing out and buffing? I read atleast 100 hrs. The drying conditions in my shop have been 40-45% humidity and 60-70 degrees. I was just curious to hear some thoughts on those that use this product. Thanks, Jeff |
|
| Author: | SteveSmith [ Sat Dec 05, 2009 11:05 am ] |
| Post subject: | Re: waiting on finish to cure.... |
I've only done one but I did parts of it twice and seemed to work just fine after 5 full days. |
|
| Author: | Ken C [ Sat Dec 05, 2009 11:31 am ] |
| Post subject: | Re: waiting on finish to cure.... |
Hi Jeff, I just finished spraying my mad rose OM with EM6000. Put the last coats on Thursday. I'll wait until next Saturday. Jeff Weiss at Target claims 100 hours is sufficient, but I usually wait at least a week. If I am in no rush, I'll wait 10 days. Ken |
|
| Author: | joekelly9692 [ Sat Dec 05, 2009 12:10 pm ] |
| Post subject: | Re: waiting on finish to cure.... |
i have finished many instruments with this stuff and have found minimum shrink back happens after two weeks but one full week is ample....and with a good pore fill job 5 days is fine |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|