| Official Luthiers Forum! http://www.luthiersforum.com/forum/ |
|
| Finally, a bench drill press I like http://www.luthiersforum.com/forum/viewtopic.php?f=10101&t=24886 |
Page 1 of 1 |
| Author: | SteveSmith [ Fri Dec 04, 2009 9:50 am ] |
| Post subject: | Finally, a bench drill press I like |
If I had the money this would be my new bench drill press http://www.knuth.de/v2/produkt,2394.html |
|
| Author: | Haans [ Fri Dec 04, 2009 10:17 am ] |
| Post subject: | Re: Finally, a bench drill press I like |
Got to be awful fast to see that one! If I had the $$ I'd go for this radial... http://grizzly.com/products/Radial-Drill-Press/G9969 |
|
| Author: | WaddyThomson [ Fri Dec 04, 2009 11:55 am ] |
| Post subject: | Re: Finally, a bench drill press I like |
20 mm capacity is pretty slack though. |
|
| Author: | SteveSmith [ Fri Dec 04, 2009 2:20 pm ] |
| Post subject: | Re: Finally, a bench drill press I like |
WaddyThomson wrote: 20 mm capacity is pretty slack though. I use few pieces larger than 1/2" so the 3/4" would be ok for me; they do have larger, and more expensive, units. I just think it would be nice to have a precise drill press although really I'm just dreaming. Haans, I was looking at that unit earlier this year and can't afford it either so guess I'll stick with my Grizzly 14" floor model and be thankful I have a drill press at all. |
|
| Author: | John A [ Fri Dec 04, 2009 3:00 pm ] |
| Post subject: | Re: Finally, a bench drill press I like |
Haans wrote: Got to be awful fast to see that one! If I had the $$ I'd go for this radial... http://grizzly.com/products/Radial-Drill-Press/G9969 Quote: Approx. ship. weight: 525 lbs. you better put that on some extra large casters !! the shipping box must weight a lot. |
|
| Author: | Haans [ Fri Dec 04, 2009 4:50 pm ] |
| Post subject: | Re: Finally, a bench drill press I like |
Yea, sturdy ain't it? 45" swing! |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|