| Official Luthiers Forum! http://www.luthiersforum.com/forum/ |
|
| Router bit recommendations??? http://www.luthiersforum.com/forum/viewtopic.php?f=10101&t=24269 |
Page 1 of 1 |
| Author: | wbergman [ Wed Oct 21, 2009 1:02 pm ] |
| Post subject: | Router bit recommendations??? |
I am looking for down cut bits for a laminate trimmer (1/4" shank). I would like a 1/2" diameter cutter so that I only need to adjust once for rosettes; but I do not find any larger than 1/4". Are there any out there? Lacking that, is there a "best" 1/4"? |
|
| Author: | Barry Daniels [ Wed Oct 21, 2009 1:09 pm ] |
| Post subject: | Re: Router bit recommendations??? |
I have never seen a 1/2" spiral bit with a 1/4" shank. I don't think it exists. Even if it did, you probably would not want to put it in a laminate trimmer. Get a 1/4" diameter and you will be good. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|