| Official Luthiers Forum! http://www.luthiersforum.com/forum/ |
|
| Martin "D" Side Profile http://www.luthiersforum.com/forum/viewtopic.php?f=10101&t=24265 |
Page 1 of 1 |
| Author: | Gregg C [ Wed Oct 21, 2009 9:45 am ] |
| Post subject: | Martin "D" Side Profile |
Hi guys, I am preparing to start my first Non kit build, I have purchased a plexi-glass top/bottom template from LMI, I want to profile the sides for a Martin "D" Where can I find the most accurate profile ?? Would I buy a set of plans or is there a template I can buy ?? Thanks Gregg |
|
| Author: | woody b [ Wed Oct 21, 2009 12:25 pm ] |
| Post subject: | Re: Martin "D" Side Profile |
A drawing of the side profile is included in Stew Macs "Herringbone" dreadnought plans. There's side profile templates available here. http://www.aiguitars.com/luthiertools.htm#Side%20Templates I can't vouch for the accuracy of either. |
|
| Author: | Michael Dale Payne [ Wed Oct 21, 2009 1:02 pm ] |
| Post subject: | Re: Martin "D" Side Profile |
Todd Stock wrote: John Hall has the factory side profiles for most Martins. Good referal Todd One thing to consider is if you are going to use the same radii for the back and top that Martin does. If so then John would be the source. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|