| Official Luthiers Forum! http://www.luthiersforum.com/forum/ |
|
| Quick question on Taylor bridge pins... http://www.luthiersforum.com/forum/viewtopic.php?f=10101&t=23673 |
Page 1 of 1 |
| Author: | Sondre [ Thu Sep 03, 2009 7:11 am ] |
| Post subject: | Quick question on Taylor bridge pins... |
I'm restoring a 70s Taylor 855 with the moustache bridge. The bridge pins are missing, and I don't know which taper will fit the holes best (3-degree or 5-degree..?). The holes are full of glue sqeeze out, so I will have to re-drill the holes. Don't wanna mess things up by starting with the wrong reamer... Thanks! Sondre |
|
| Author: | Jim_H [ Fri Sep 04, 2009 4:13 am ] |
| Post subject: | Re: Quick question on Taylor bridge pins... |
I can't answer your question, because I don't know, but I do know that Taylor is really good about answering questions like this. If you strike out here, you might send them a note. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|