| Official Luthiers Forum! http://www.luthiersforum.com/forum/ |
|
| E. Emerson Tool Straight Clamp http://www.luthiersforum.com/forum/viewtopic.php?f=10101&t=23477 |
Page 1 of 1 |
| Author: | segovia [ Mon Aug 17, 2009 3:22 pm ] |
| Post subject: | E. Emerson Tool Straight Clamp |
Hi - Has anybody used these type of clamps holding the table and back for glueing ? http://www.eemersontool.com/Home.html John |
|
| Author: | WaddyThomson [ Mon Aug 17, 2009 3:59 pm ] |
| Post subject: | Re: E. Emerson Tool Straight Clamp |
I have. They work fine, but you have to be careful not to over clamp. I flip them upside down, and put little half circle on the grip plates, if the back or top plates aren't square, then I put weights |
|
| Author: | segovia [ Wed Oct 14, 2009 2:16 pm ] |
| Post subject: | Re: E. Emerson Tool Straight Clamp |
Hi I just ordered three of these http://www.rutlands.co.uk/cgi-bin/psProdDet.cgi/DK1220 If you have any pictures of your set up I would be interested is seeing your approach Thanks John |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|