| Official Luthiers Forum! http://www.luthiersforum.com/forum/ |
|
| Bridge pins at an angle? http://www.luthiersforum.com/forum/viewtopic.php?f=10101&t=23133 |
Page 1 of 1 |
| Author: | Ed Haney [ Sun Jul 19, 2009 8:56 am ] |
| Post subject: | Bridge pins at an angle? |
Are bridge pin holes ever purposely drilled at an angle so that the bridge pins slant towards the end-pin away from the saddle? I have a guitar where that is the case and I am wondering if I would correct them to be straight up and down. Ed |
|
| Author: | peterm [ Sun Jul 19, 2009 12:30 pm ] |
| Post subject: | Re: Bridge pins at an angle? |
I've seen it done both ways. Not to worry. |
|
| Author: | paul h [ Sun Jul 19, 2009 5:49 pm ] |
| Post subject: | Re: Bridge pins at an angle? |
I slant the saddle slot back a few degrees, and drill the holes to match. I don't think there is any reason to change what you have. Paul |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|