| Official Luthiers Forum! http://www.luthiersforum.com/forum/ |
|
| Do you have a 10-20 performax/jet sander with a stand? http://www.luthiersforum.com/forum/viewtopic.php?f=10101&t=22862 |
Page 1 of 1 |
| Author: | Mike OMelia [ Wed Jun 24, 2009 8:16 pm ] |
| Post subject: | Do you have a 10-20 performax/jet sander with a stand? |
If you do, and your stand has the metal shelf, could you please measure the shelf width & length (if you have one)? Yes, I know the top & bottom are slightly different due to the slant angle of the legs. But I think I can get there with measurments of the top or bottom...just let me know which side you measured (top or bottom). Thanks so much! Mike |
|
| Author: | woody b [ Wed Jun 24, 2009 8:22 pm ] |
| Post subject: | Re: Do you have a 10-20 performax/jet sander with a stand? |
Mike I've got one. I'm in for the night. I'll measure it first thing tomorrow. |
|
| Author: | Mike OMelia [ Wed Jun 24, 2009 9:22 pm ] |
| Post subject: | Re: Do you have a 10-20 performax/jet sander with a stand? |
Woody, Thanks so much! I could measure it from the stand alone, but chances are, given the flex and all of that, I would get it wrong and end up torquing the legs improperly. I can't believe they ever sold these without the shelf. And drilled the holes in the legs to boot! Mike |
|
| Author: | woody b [ Thu Jun 25, 2009 6:15 am ] |
| Post subject: | Re: Do you have a 10-20 performax/jet sander with a stand? |
The top of the shelf measures 28 1/4" X 16 3/8". It's 21 3/16" from the top of the stand to the top of the shelf. Let me know if you need more measurements. |
|
| Author: | Mike OMelia [ Thu Jun 25, 2009 10:32 am ] |
| Post subject: | Re: Do you have a 10-20 performax/jet sander with a stand? |
Thanks Woody, that should do it! Mike |
|
| Author: | Mike OMelia [ Thu Jun 25, 2009 9:17 pm ] |
| Post subject: | Re: Do you have a 10-20 performax/jet sander with a stand? |
Funny thing happened. I have a 10-20. When I got the stand together, it was too wide. Would fit a 16-32 just fine. I missed that when I bought the item. Then the guy who sold it to me sent me a PDF manual explaining they only make one stand for both models. The end foot on the 10-20 is reversible. When I reversed it, all four holes lined up fine! Yes, I can be such a doofus. Mike |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|